03 9886 9294

2l Barina Road, Glen Iris, Victoria 3146

Drimaster & Flatmaster

 

Whole House Ventilation
 

Drimaster for Whole House

 

Positive Input Ventilation


The Drimaster provides whole house ventilation using the Positive Input Ventilation principle.

Positive Input Ventilation within the house assists in the dilution and removal of pollutants as well as a reduction in humidity/condensation (the cause of mould and mildew) which, combined creates a more pleasant environment and relief for asthma and allergy suffers.

The Drimaster provides the most energy efficient, cost effective way of ventilating a home.
· Ventilates every room
· Significantly improves indoor air quality
· Eliminates mould and mildew
· Solar gain benefits
· Fully automatic
· Extremely low power consumption - (on average uses 5 watts of power/hr)
· Whisper quit
· 6 Speed settings to suit individual properties
· System standby mode during summer months
· Very low maintenance requirement(filter replacement ever 5 years)
· 5 Year Mechanical Warranty

 

Flatmaster for Flats and Apartments

 

Positive Input Ventilation


The Flatmaster provides whole home ventilation using the positive input Ventilation principle.

The concept is to introduce air to the home at a continuous low rate, encouraging movement of air from inside to outside.

A single unit situated in a convenient location within the property and associated ductwork will normally be sufficient to continuously dilute, displace and replace the old contamined air in the home with drier,filtered air. The result is a significant contribution towards providing a healthy, condensation dampness free and mould free, energy efficient home.

 

Sub Floor Ventilation


We provide consultation, design and installation service for sub-floor ventilation solutions.

We design customised sub-floor ventilation systems to solve the problem of inadequate air movement in the sub-floor.

Ground moisture below floors with inadequate ventilation causes the relative humidity to rise. This can be the source of several problems. Mould spores that are always present in the air begin to germinate in high humidity. This is the cause of mould and mildew, which can spread inside the house and is normally accompanied by an unpleasant musty odour. Sub-floor moisture can be absorbed by the plaster and brickwork and over time rises upward to cause flaking of paintwork and powdering of plaster. Excess moisture below the floor is often absorbed by the untreated lower surface of the timber floors causing the boards to swell which leads to "cupping". in severe cases it leads to rotting of timber floorboard and bearers. Also termites, woodborer and cockroaches thrive in the damp, dark conditions. Mechanical ventilation solves these problems.